Sender information, Picture mail recipients, Password – Nikon Coolpix S50c User Manual

Page 143

Advertising
background image

129

Wireless LAN Settings for the Camera

Wi
re

le

ss

Se
rv

ic

es

j

MAC Address Filtering

When MAC address filtering is enabled, only devices with an authorized MAC address can
access the wireless LAN. Check the camera’s MAC address in [Firmware version] of the setup
menu (c 123) and add it to the authorized list.

Sender Information

To use COOLPIX CONNECT services, the sender’s alias (up to 16 alphanumer-
ical characters) and e-mail address (up to 64 alphanumerical characters;
mobile telephone e-mail addresses are not supported) must be configured
with the camera to register user information on a Picture Mail server or a Pic-
ture Bank server (c 152). Once the user information has been registered,
user information can not be edited from the camera or the Utility.

Picture Mail Recipients

With Picture Mail, e-mail notification can be sent automatically to specified
recipients whenever pictures are uploaded to the server. Up to 30 recipients
can be specified. An alias (up to 16 alphanumerical characters) and e-mail
address (up to 64 alphanumerical characters; mobile telephone e-mail
addresses are not supported) must be entered for each recipient.

Password

A password (four-digit number) can be applied to prevent unauthorized
access to COOLPIX CONNECT services by third parties and to protect infor-
mation stored in the camera.

Encryption key

Enter the encryption key, provided by the network administrator, for the

selected authentication method. This is not necessary when [Authentication] is

set to [Open system] and [Encryption] is set to [None].

Key index

When [Encryption] is set to [WEP], select the same key index used by the

access point (unnecessary when [Encryption] is set to [None], [TKIP], or [AES]).

The default setting is [1]. Use the Utility to specify a setting other than [1].

Configuration

Select the method for specifying the camera’s IP address from [Auto] (default

setting) or [Manual].

IP address

When [Configuration] is set to [Manual], enter an IP address, along with a sub-

net mask, gateway, primary DNS, and secondary DNS for the camera.

(mandatory configuration)

Advertising
This manual is related to the following products: