Northern Industrial Tools 109088 - Manual (Page 2)

For technical questions and replacement parts, please call 1-800-556-7885.
Thank you very much for choosing a NORTHERN TOOL & EQUIPMENT CO., Product! For
future reference, please complete the owner’s record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire
instruction sheet to become familiar with this product before you begin using it.
This machine is designed for certain applications only. Northern Tool & Equipment strongly
recommends that this machine is not modified and/or used for any application other than that
for which it was designed. If you have any questions relative to a particular application, DO NOT
use the machine until you have first contacted Northern Tool & Equipment to determine if it can
or should be performed on the product.
Before using this product, please read the following instructions carefully.
WARNING!
Do not extract caustic or flammable products. Do not expose the reservoir to any source of
heat. While extracting high temperature oils, keep hands and face protected. Only use the
device for the purpose for which it has been designed. Do not modify any component of the
equipment. Only use original spare parts. Our technical office is at your full disposal for any
information you may need.
ATTENTION!
Some cars have a built-in oil suction probe. In this case, connect the coupler of the oil
changer B directly to the probe. For other makes of car (Volkswagen and BMW) equipped with
a built-in probe having a different opening, connector(C-Volkswagen, D-BMW) must be used.
OPERATION
Fig.1：Close the suction valve (ball valve) A.
Hand tighten the drain cap B.
1