Napco Security Technologies NAPCO EXPRESS XP-600 - Manual (Page 15)

15
Ambush Code - In the event that you
are forced by an intruder to disarm your
system, this special code can be used to
disarm the system, and simultaneously
send a silent alarm to Central Station. If
your system has the Ambush feature en-
abled, the code assigned as the User 6
code will function as your Ambush Code.
Arming / Disarming - Turning the sys-
tem on or off by entering your user code
at the keypad.
Auto Interior Bypass - A feature which
allows the system to recognize when
you have not left the premises and auto-
matically bypass any interior zones, de-
activating devices such as motion sen-
sors, allowing free movement throughout
the premises.
Battery - A backup source of power to
provide protection for a limited time in
the event of a power failure.
Bypass - the manual or automatic re-
moval of one or more protection zones
from the system. Press
C and then
the zone number to bypass a zone.
Central Station - Monitors alarm, emer-
gency and trouble reports from the alarm
system and notifies proper authorities.
Chime - a keypad beep which indicates
that a door has been opened while the
system is disarmed.
Easy Exit - Allows an occupant to leave
the premises without disarming the sys-
tem. Pressing
A and then 0 while
the system is armed will permit exit by
removing the protection on the Exit/Entry
door for 3 minutes.
Exit/Entry Delay - The amount of time
you are allowed to enter and leave the
premises when the system is armed.
Exit/Entry Zone - A zone which will al-
low you to enter and leave the premises
when the system is armed.
Instant Protection - Arming without En-
try Delay while remaining on the prem-
ises. (Press
A 4 while armed).
Keypad Sounder - A local warning de-
vice at the keypad to alert that Entry de-
lay has started.
System Trouble - A problem has been
detected in the system which may pre-
vent it from working properly. The
H SYSTEM light will be lit.
User Code - A four digit code which is
used to arm and disarm the system from
the keypad.
User 1 Code - A four digit code which
can be used to program, re-program and
erase user codes, as well as arm and
disarm the system from the keypad.
Zone - An area which is protected by a
security device. Your front door may be
designated as Zone 1, while the living
room motion detector may be Zone 2.
Refer to the Zone Label on your keypad
for the Zone Identification of your sys-
tem.
Glossary