NordicTrack NTCCXC80180 - Manual (Page 12)

12
b. Roughen the surface of the resistance pad with 100-grit sandpaper. Oil the leather resistance
pad with one or two drops of light household oil. Spread the oil over the resistance pad.
c. Oil the 3/8” washers and the thrust washer if needed.
PROBLEM: The flywheel and/or the resistance strap offers no resistance.
SOLUTION: a. Check the routing of the resistance strap.
b. Make sure the flywheel is tight. Remove the “U” bolt cover from the flywheel (see page 9).
Evenly tighten the two 1/4” nuts located on the right side of the flywheel.
PROBLEM: The skis are slipping.
SOLUTION: a. Wipe off any excess oil.
b. Clean the bottom of the skis with a dry cloth or a small amount of mineral spirits or paint thinner.
c. Make sure that the flywheel is tight. Remove the “U” bolt cover from the flywheel (see page 9).
Evenly tighten the two 1/4” nuts located on the right side of the flywheel.
PROBLEM: The rollers are squeaking or sticking.
SOLUTION: See GENERAL LUBRICATION on page 10.