NordicTrack NTCCEX04902 - Manual (Page 7)

7
9. Identify the Left Pedal (69) (there is an “L” on the
Left Pedal for identification). Using an adjustable
wrench, firmly tighten the Left Pedal counterclock-
wise into the Left Crank Arm (51). Tighten the Right
Pedal (not shown) clockwise into the Right Crank
Arm (not shown). Tighten both Pedals as firmly
as possible.
Important: After using the recumbent cycle for
one week, retighten the pedals. For best perfor-
mance, the pedals must be kept properly tight-
ened.
21
69
51
9
10. Make sure that all parts are properly tightened before you use the recumbent cycle. Place a mat
beneath the recumbent cycle to protect the floor.
8. Position the Seat Carriage (6) as shown. Slide the
Seat Rail Cover (84) into the slot in the Seat Rail
(7). The beveled end of the Seat Rail Cover should
be flush with the end of the Seat Rail. Attach a Seat
Stop (77) and the Seat Rail Cover to the Seat Rail
with an M4 x 16mm Screw (64).
Press the Seat Rail Cap (13) into the end of the
Seat Rail (7).
77
64
13
7
84
Slot
6
8