Trouble shooting – Nilfisk-Advance America GR 8000 User Manual

Page 14

Advertising
background image

English

14





Symptom Possible

cause

Action

No power

Not connected / Faulty socket

Check connection to wall socket and
socket switch. Try in another wall socket

On / Off switch not on

Press On / Off switch which will illuminate
when on

Fuse blown

Replace fuse with approved 13A fuse

Unknown Call

for

service

No steam

Steam Control turned down fully
clockwise

Turn the control to half way

Steamer not ready

Wait for the “Ready to steam” light to
illuminate

Clean water tank is low (beeping
sound& "refill" light is lit)

Pour water into the clean water tank until
the beeper stops. The steam handle will
work again.

Unknown Call

for

service

No steam, Just water

Steamer not ready

Wait for the "Ready to steam " light to
illuminate

Boiler at pressure and not
heating(temperature less than 110ºC)

Hold the steam switch on for
approximately one minute, ever if just
water is coming out. This will result in the
heater coming back on

Unknown Call

for

service

Steam Leaking from front
socket

“O” Rings split

Change and re grease “O” Rings. To
avoid this happening ensure “o” rings are
grease before every use.

“O” rings worn

Change and re grease “O” Rings. To
avoid this happening ensure “o” rings are
grease before every use.

No detergent

Solution tank empty

Pour cleaning solution diluted in
accordance with the manufacturers
instructions into the solution tank.

Unknown Call

for

service

Trouble Shooting

Advertising