Netopia 3347NWG-VGx - Manual (Page 11)

7
Section 5:
Connecting the DSL Gateway
Ethernet LAN connection method (wired LAN)
The following instructions are for connecting PCs to the DSL gateway. Up to
four individual PCs can share the DSL service by connecting directly to the
DSL gateway. Please verify that the PCs meet the System Requirements in
Section 2. For connecting to an existing LAN you need to connect the
Ethernet port to your hub.
1
Place the DSL gateway near your PC or another location that permits
easy access and visibility. Make sure any Ethernet cables are kept away
from power cords, fluorescent lighting fixtures, and other sources of
electrical interference. Put the DSL gateway in a location where air can
circulate freely around it.
2
Plug the power supply to the power jack on the back of the DSL
gateway and into a surge-protected AC outlet (1) .
3
Turn on the power using the power switch. The Power light should
come on solid green.
4
Plug one end of the lavender telephone cable (2) into the DSL wall
jack, and the other end into the port labeled DSL on the back of the
DSL gateway. The DSL Sync indicator light should blink for up to two
minutes then light solid green. Note that the light will flash green as
data flows through the device.
Ethernet LAN Connection Example