Nautique 220 - Manual (Page 159)

Correct Craft, Inc. 8-4
Propeller
Removal
1. Remove the cotter pin from the propeller shaft and discard.
2. Wedge a piece of 1" x 4" wood between the propeller blade and
the starboard side of the strut and rudder.
3. Remove the nylon locknut and discard.
Section 8
• A propeller can be very sharp. Be careful when you
handle it. Wear a pair of protective gloves when
handling any propeller.
• Remove your key from the ignition and remove the
Emergency Stop Switch clip from the switch to
prevent accidental starting of the engine.
• DO NOT reuse the nylon locknut or the cotter pin.
• DO NOT use a damaged propeller. A damaged
propeller can damage your engine and boat.
CAUTION
Naut Air Sec 8.qxd 8/29/06 4:24 PM Page 8-4