Nostalgia Electrics Retro RHD-400 - Manual (Page 4)

ENGLISH 3
SET UP INSTRUCTIONS
Your RETRO HOT DOG ROLLER ™ requires little assembly.
 Place roller assembly in unit, making sure the pin fits correctly into the fitting on the left
hand side of the base interior. IMPORTANT: Notice the shape of the receptacle in the
base and the endpin on the roller assembly (see Illustration A below). They are fitted
to work together. DO NOT force the pin into the receptacle or it will strip and then
cannot control the roller action (see Illustrations A and B below).
 Fit the four canopy poles into the holes in each corner of the unit. Insert the drip tray
in the slot at the back of the unit. (See illustration C below).
 Attach the canopy top to the poles.
Do not attempt to place roller assembly on base or remove from base while motor is
on.
IMPORTANT Notice the shape of the receptacle in the base, and the endpin on the roller
assembly. They are fitted to work together.
A B
c
NOTE: To prolong the life of your RETRO HOT DOG ROLLER™, follow the cleaning
instructions provided on page 4 after every use and make sure the roller assembly is fitted
properly in the base unit as shown above. DO NOT force it or it will strip the fitting and the
rollers will not be able to be controlled for proper rotating.
Pin on Roller
Assembly
Receptacle