Anykey answer, Automatic redial, Speed dialing – Nokia 3155i User Manual
Page 50: Automatic update of service

S e t t i n g s
49
In the standby mode, select
Menu
>
Settings
>
Call
>
Location info sharing
.
Select
More
to read the disclaimer, then select
OK
. Select from the options:
Emergency
—This is the default profile. The device location information is shared
only during an emergency call to the official emergency number programmed
into your device. The screen displays
in the upper left hand corner in the
standby mode.
On
—The device location information is shared with the network whenever the
device is powered on and activated. The screen displays
in the upper left
hand corner in the standby mode.
Location information will always be shared with the network during emergency
calls to the official emergency number programmed into the device, regardless of
which setting is selected. After placing an emergency call the device remains in
emergency mode for 5 minutes. During this time, the location information will be
shared with the network. See "Emergency calls," p. 78.
Anykey answer
Anykey answer enables you to answer an incoming call. Briefly press any key
except the right selection key or end key.
In the standby mode, select
Menu
>
Settings
>
Call
>
Anykey answer
>
On
or
Off
.
Automatic redial
Occasionally, your network may experience heavy traffic, resulting in a fast busy
signal when you dial. With automatic redial activated, your device redials the
number (number of times is specified by the network), and notifies you when the
network is available.
In the standby mode, select
Menu
>
Settings
>
Call
>
Automatic redial
>
On
or
Off
.
Speed dialing
You can activate or deactivate speed dialing. In the standby mode, select
Menu
>
Settings
>
Call
>
Speed dialing
>
On
or
Off
. See "Set up speed dialing," p. 38.
Automatic update of service
With automatic update of service, your device will automatically update the
service when the network is available.
In the standby mode, select
Menu
>
Settings
>
Call
>
Automatic update of
service
>
On
or
Off
.