Nokia Ethernet bridge adapters 100BASE-T - Manual (Page 8)

Product Overview
8 (14) © Nokia Corporation
DN0610789
Table 1. E66210.33 bridging
Link speed 10BASE 10BASE 100BASE
Duplex status Half Full Full
Closed pins 1-2 3-4 5-6
LED 100 Off Off On
LED HD On Off Off
Installing E66210.32
Figure 7. Installing the adapter
1. Switch off the modem power, plug the ET-adapter into the slot and
tighten two screws. Then switch on the modem. The ET-adapter is ready
to use.
Installing E66210.33
1. Select Ethernet interface configuration and close pins of NR3 according
to Table 1.
2. Switch off the modem power, plug the ET-adapter into the slot and
tighten two screws. Then switch on the modem. The ET-adapter is ready
to use.