Nortel Networks 8600 - Manual (Page 12)

12 Determining hardware and software compatibility
320180-A Rev 00
Determining hardware and software compatibility
The matrix below describes your hardware and the minimum Passport 8000 Series
Switch software version required to support the hardware.
Chassis & switching fabric
Minimum
software version Part
number
8010co chassis 10-slot chassis 3.1.2 DS1402004
8010 chassis 10-slot chassis 3.0.0 DS1402001
8006 chassis 6-slot chassis 3.0.0 DS1402002
8003 chassis 3-slot chassis 3.1.2 DS1402003
8690SF Discontinued, see 8691SF or 8692SF 3.0.0 DS1404001
8690SF/256 8690SF with 256MB SDRAM
installed. Discontinued. See 8691SF
or 8692SF 3.0.0 DS1404089
8691SF Switching fabric 3.1.1 DS1404025
8691SF/256 8691SF/256 with 256 SDRAM
installed 3.1.1 DS140490
8692SF Switching fabric 3.5.6 1
1 The 8692SF is supported on all Passport 8600 Series Switch 3.7.x software releases.
DS1404065
Power Supplies
8001AC 690W AC Power Supply 3.0.0 DS1405x01
8002DC 780W DC Power Supply 3.0.0 DS1405002
8003AC 500W AC Power Supply (8003
chassis only) 3.1.2 DS1405x03
8004AC 850W AC Power Supply 3.1.2 DS1405x08
8004DC 850W DC Power Supply 3.1.2 DS1405007
Upgrade Kits
256MB CPU upgrade kit This memory upgrade may be
required for the 3.5 and 3.7 software
to run properly.
2
2 With the Passport 8000 Series Switch Software Release 3.5 and higher, you must upgrade the 8690SF to 256MB.
Nortel Networks recommends that you upgrade the 8691SF to 256MB.
3.5.0 DS1404016
MAC upgrade kit Use this kit to add Media Access
Control (MAC) addresses to your
system. This kit is required for routed
interface scaling beyond 500. 3.5.0 DS1404015