Nexgrill 720-0140-LP - Manual (Page 17)

ASSEMBLY INSTRUCTIONS
Step 5: Replace “U” brackets with 4(four) Step 6: Align & tighten knob seat & valve
Screws( DO NOT TIGHTEN) stem with 2(two) screws & washers
Note:(Make sure hose is not bent) as shown below.
Step 7;Tighten all 4(four) screws on the “U” Step 8: Place knob on valve stem and secure
brackets on the burner, then connect with the wrench tool.
the ignition wire on to valve.
(wrench tool enclosed in bag)
Valve Stem
Knob Seat
Ignition wire
**Important Note! Make Sure Side Burner Hose Is not Bent**
15