3 operating the navigation software, 1 volume, 2 information – Navigon 7110 User Manual
Page 14: Operating the navigation software, Volume, Information, 3operating the navigation software
User's manual
NAVIGON 7100 | 7110
- 14 -
Operating the navigation software
3
Operating the navigation software
3.1
Volume
The volume of the spoken driving instructions can be adjusted during
navigation.
You have started navigation. The map is open in Navigation or
Destination search mode.
1. Tap
the
(Volume
)
button.
The volume bar opens. It contains three buttons for adjusting the
volume:
(Louder
)
,
(Quieter
)
,
(Volume on/off
)
.
2. Tap
the
(Volume
)
button again.
The volume bar closes.
3.2
Information
Symbols located at the top of the screen are used to display
information.
GPS
The GPS symbol can show the following GPS-reception status:
No GPS: The built-in GPS receiver is not operational. Contact customer
service if the problem persists.
No Signal: Data is being received from less than three satellites.
Position cannot be calculated.
GPS Ready: Data is being received from at least three satellites.
Position can be calculated.
For more detailed information regarding GPS status, please refer to
chapter "GPS status" on page 43.
Energy
The Energy symbol can display the following conditions of the built-in
battery: