Numark Industries MPCD33 - Manual (Page 14)

MPCD33
FADER START
Fader Start is achievable by attaching your CD player to a similarly equipped DJ mixer and setting the rear panel selection switch
to “mixer” mode.
1. Connect cables between the CD player and your DJ mixer.
2. Press the button or switch on your mixer into fader start mode to activate the fader start capability.
3. Typically if you move the crossfader toward the active channel, the attached CD player will activate. When it is moved away the
unit will cue or pause depending upon CD player setting.
To select start/stop mode hold the time button for 3 seconds.
If the display shows then the CD will pause when the crossfader is moved away.
If the display shows then the CD will CUE when the crossfader is moved away.
REMOTE SWITCH START
Remote switch start is achievable by attaching your CD player to a switch like a foot switch found in most music shops. Foot
switch connector plugs are often ¼” and an adapter to 1/8” will be needed for connection.
1. Connect the remote switch to your CD player.
2. Select the type of foot switch you will use. There are two types of footswitches that will work with this connector. The first is a
typical, ON-OFF pushbutton switch and are generally used for switching channels on guitar amps. The second switch is a
momentary footswitch and is usually used for keyboard sustain pedals. If you are unsure of the style of switch you have, try each
position until it works as desired.
3. Typically if you press the switch once, the attached CD player will activate. When it is pressed again the unit will cue or pause
depending upon CD player setting.
Note: You can also use a momentary switch in the ON-OFF switch position. In this case the unit will only play while the
switch is depressed. When the button is release it will either cue or pause depending upon mode.
BEFORE SWITCHING OFF THE POWER:
When you have finished using the CD player, be sure that the disc tray is closed with the “OPEN/CLOSE” button before
switching off the power.
DO NOT switch off the power when
the disc holder is open.
Switch off the power after the
disc holder has been closed
with the “OPEN/CLOSE” button
- The Leader in DJ Technology
©2002 Numark Industries - 14 - http://www.numark.com