Eizo FlexScan L362T - Manual (Page 15)

English
2-3. Connecting two PCs to the monitor
Two PCs can be connected to the monitor through the DVI and the D-Sub mini 15 pin
connector on the back of the monitor.
Selecting the active input
The Input Signal Selection Button on the control panel can be used to select either Signal
1 or Signal 2 as the active input at any time. Every time the button is pressed, the input
changes. When switching the signal, the kind of the input signal (Signal1 or 2/Analog or
Digital) is displayed for a few seconds on the right top corner of the screen.
SIG. AUTO ENT.
2-4. Sound Connections
NOTE
• Always switch the monitor and audio devices or computers off whenever connecting
or disconnecting any audio devices (computer or CD player) to the monitor.
• Use the enclosed stereo mini-jack cable for connecting audio devices or computers
to the monitor.
1.
Connect the stereo mini-jack cable to the external line in of the
monitor.
2.
Connect the other side of stereo mini-jack cable to the line out of
audio devices.
POWER INPUT POWER INPUT DVI D-SUB
Volume control
Volume control
Press the Right and Left Buttons.
Mute Press the Up or Down Button for a while after pressing the Right or Left
Button to display the volume control bar.
Mute off Press the Right or Left Button.
NOTE
• <Sound> menu of the ScreenManager also controls the sound.
Computer or
CD Player
Input Signal Selection Button
2. CABLE CONNECTION
15