NordicTrack NTST07900 User Manual
Page 6
5. While another person holds the Console (4) near the
Upright (3), connect the console wire to the Extension
Harness (77). Insert any slack wire into the Upright.
Attach the Console (4) to the Upright (3) with four
Console Screws (57) and four M10 Split Washers (30).
Make sure that the console wire and the Extension
Wire (77) are not pinched.
Snap the bookrack onto the Console (4) as shown.
5
6
4. Hold two Handlebar Bushings (92) around the rectangu-
lar tube on the left side of the Upright (3). Slide the Left
Handlebar (6) onto the Handlebar Bushings and the
tube on the Upright. Attach the Left Handlebar with two
M8 x 35mm Button Bolts (24), two M8 Split Washers
(54), and two M8 Nylon Locknuts (28). The Nylon
Locknuts must be very tight.
Attach the Right Handlebar (5) in the same way.
4
6
5
28
54
3
24
92
92
4
Console Wire
Bookrack
3
30
30
57
57
6. Make sure that all parts of the stepper are properly tightened. Note: Some hardware may be left over
after assembly is completed. To protect the floor or carpet from damage, place a mat under the stepper.
77