NordicTrack 5500 R NTL19940 - Manual (Page 8)

8
2. Make sure that the power cord is unplugged. Remove
the indicated screws from the Console Back (89).
Important: The screws may be different lengths.
Remember which screws were removed from which
holes. Remove the Console (81).
3. Peel the paper off the pad on the bottom of the receiver
(A). Turn the receiver so the small cylinder is on the
side shown, and press the receiver into the bottom of
the Console Base (130) in the indicated location.
4. Connect the included short jumper wire (B) to the wire on
the receiver (A). Connect the other end of the short
jumper wire to the PLS2 jack on the back of the Console
(81). If there is a wire already plugged into the PLS2 jack,
unplug it. Note: The other wires included with the receiver
may be discarded. Use the included wire tie to secure
wires, if needed.
Make sure that no wires are pinched. See step 2.
Reattach the Console (81) with the screws. Important: If
the screws are not put back into the same holes from
which they were removed, the Console will be dam-
aged.
See step 1. Reattach the Upper Handrail (19).
1. While holding the Upper Handrail (19), remove the two
3” Bolts (56) and Handrail Washers (69) from the
Uprights (99) as shown.
1
56
69
19
99
118 118
56
OPTIONAL CHEST PULSE ASSEMBLY
If you purchase the optional chest pulse sensor (see page 25), follow the steps below to install the re-
ceiver and the short jumper wire included with the chest pulse sensor.
89
81
Screws
2
3
130
A
Cylinder
81
A
B
4
PLS2
Jack