Nova Retrofit Kit 50-0-1818-34 - Manual (Page 3)

4
9
10
FIGURE 3
As shown in Figure 3, attach Left Keyboard Hanger securely
to the underside of the worksurface using three (3) Screws
(Ref. #9) and one (1) Screw (Ref. #10). Repeat procedure for
other side.
IMPORTANT: The longer of the screws (Ref. #10) passes
through the tubular section of the Keyboard Hanger allowing
the assembly to be leveled by either tightening or loosening
the screw. Adjusting the screws allows you to fine-tune the
action of the keyboard drawer.
Install Trim Ring by snapping pieces together (Ref. #14 and
#15), lowering into cutout, and attaching with four (4) screws
(Ref. #12).
Step 9
Adjusting Your Monitor: The Monitor Support adjusts three
ways — height (up/down), angle, and forward/backward.
Adjust it so that you have a comfortable viewing angle of the
monitor when you're in a normal working position. Push
Outward Locking Tabs back to unlock keyboard drawer. See
Figure 4. Remove the keyboard drawer and the glass. Lower
the monitor through the viewport opening while allowing the
wires to feed through the back of the monitor support. If the
monitor is too heavy, make sure you get assistance.
Step 10.1 EXPLODED VIEW
Page 3
T
9
10
Step 7
Outward
Locking
Tab
FIGURE 4
8
8
13
10
8
8
13
3
9
12
11
2
6
2
5
9
9
9
3
10
9
10
4
50-0-1818 Asy. Instr., © Nova Solutions, Inc. 2002
After installing the Keyboard Drawer, pull Outward Locking
Tab forward to lock in place. See Figure 4.
Step 8
1
1
Angle Forward-Backward Up-Down