Nautique Crossover 90490 - Manual (Page 83)

4-15
Controls and Indicators
NOTICE
The “System Indicator Light” is on the right side of the ignition
keypad. The “Ignition Indicator Light” is on the left side of the
ignition keypad.
Programming the Primary User Code
NOTICE
Until a Primary User Code is set, the keyless ignition does not
require the entry of a code to unlock the system or start the engine.
This system operates as follows:
1. Press START to unlock the system.
2. Press it a second time to start the engine.
3. Press STOP to turn off the engine.
4. Press it a second time to lock the system. The system indicator
light should be off.
To program the Primary User Code, make sure the system indicator
light is off, then press and release the 1/2 key and the 7/8 key at
the same time to put the system in the Code Programming Mode.
The system indicator light will flash.
Enter a code from two to eight characters and press START. For
verification, reenter the code and press START again. The system
indicator light should stop flashing and stay on. If the light does not
stop flashing, press STOP and begin again.
To lock the system, reenter either the Primary User Code or the
Master Embedded Code and press STOP.
216V Sec 4_2009.qxd:Naut Air Sec 4.qxd 1/21/09 9:21 AM Page 15