Nextar XPJ - Manual (Page 12)

12
Connection
When connecting a signal source to the projector, be sure to:
1. Turn all equipment off before making any connections;
2. Use the correct signal cables for each source; and
3. Ensure that the cables are firmly inserted.
In the connections shown below, some cables may not be included with the projector (see "Shipping
Contents" on page 6 ). They are commercially available from electronics stores.
Cable connection
Connecting video source devices
This section describes how to connect the projector to video source devices using video cables. Video cable
connections are recommended for video presentations.
You can connect your projector to various video source devices that provide any one of the following output
sockets:
λ S-Video
λ Video (composite)
You need only connect the projector to a video source device using just one of the above connecting
methods; however, each provides a different level of video quality. The method you choose will most likely
depend upon the availability of matching terminals on both the projector and the video source device as
described below:
Better video quality
The S-Video method provides a better quality analog video than standard composite video.
If you have both composite Video and S-Video output terminals on your video source device, you should elect to
use the S-Video option.
Lesser video quality
Composite Video is an analog video and will result in a perfectly acceptable, but less than optimal, result from your
projector, being the lesser video quality of the available methods described here.
Connecting audio
The projector has a built-in mono speaker that is designed to provide basic audio functionality accompanying data
presentations for business purposes only. It is not designed for, nor intended for, stereo audio reproduction use as
might be expected in home theatre or home cinema applications. Any stereo audio input (if provided) is mixed into a
common mono audio output through the projector speaker.