Quick setup diagram, Specifications, Rm6 - the leader in dj technology – Numark Industries RM6 User Manual
Page 6
RM6
- The Leader in DJ Technology
©1999
Industries
- 6 -
http://www.numark.com
ring
tip
sleeve
+
-
gnd
2
3 1
Quick Setup Diagram
Study this setup diagram. There are many options available for your particular needs and this is just one possibility. Make
sure all faders are at "zero" and all devices are off. First, connect all input sources. Next, connect the stereo outputs to the power
amplifier(s) and/or audio receivers such as tape decks. Plug your mixer into AC power. Now you are ready to switch everything on.
IMPORTANT: Always switch on your audio input sources such as turntables or CD players first, then your mixer, and finally any
amplifiers. When turning off, always reverse this operation by turning off amplifiers, then your mixer, and then input devices.
TUNER
Neutrik™ “Combo” connector proper wiring - allows connection of either a 1/4” jack or an XLR jack to connect balanced line or mic inputs
depending upon switch position. You should wire tour connections according to the following chart details
MODE:
POSITION
Line Stereo:
1=ground, 2=left, 3=right
Line Mono:
1=ground, 2=signal, 3=ground
Mic Balanced:
1=ground, 2= “+”, 3= “-“
Mic Unbalanced:
1=ground, 2=signal, 3=ground
Specifications
Inputs:
Line:
10K input impedance
140mV rms sensitivity (for 1V output)
Mic 1:
10K input impedance unbalanced
1.5mV rms sensitivity (for 1V output)
60mV rms max input
Mic 2/Mic3:
10K input impedance
2.5mV rms sensitivity (for 1V output)
80mV rms max input
Outputs:
Line:
9V rms max
Headphone:
0.5 watt into 47 ohm
Distortion:
less than 0.01%
Signal to Noise Ratio: (vs. maximum output)
Line:
better than 92dB
Mic 1:
better than 90dB
Mic 2/Mic3:
better than 80dB
Phono:
better than 80dB
Frequency response:
Line:
20Hz - 22KHz +/-0.5dB
Mic's:
20Hz - 18KHz +/-0.5dB
Phono:
+/-1dB except for controlled attenuation of -3dB
@20Hz to reduce rumble and feedback
Equalizations: (Mic1 / Zone A / Zone B)
Bass:
+/-13dB
Middle:
+/-14dB
Treble:
+/-12dB
Power consumption:
10.2 watt typical
12.8 watt with full output
Dimensions:
480mm (W) x 44mm (H) x 200mm (D)
Weight:
2.2 kgs
5 lbs
1
2
3