Numark Industries DM1235 - Manual (Page 8)

DM1200/DM1235/DM1285
DJ MIC SECTION
Your mixer has an extremely flexible DJ Mic channel.
The Talkover function reduces the level of the music
while leaving the DJ Mic at normal volume.
7. Neutrik™ “Combo” connector allows connection of
either a 1/4” jack or an XLR jack. This is ideal for
connecting an XLR gooseneck directly into the mixer.
8. Treble and Bass Controls fine-tune the tone of your
voice on both mics through the sound system. The
controls are detented for setting tone "flat". For best
results, use a dynamic cardioid microphone.
9. The DJ Mic 1 Fader controls the DJ Mic volume for
the Neutrik™ “Combo” connector.
10.The Mic 2 Fader controls the Mic volume for the
1/4” connector on the rear of the mixer.
11.Mic Off/On/Talkover Switch. O f f / O n turns Mic 1
off and on. Mic 2 is controlled only through the Mic 2
Fader. Talkover turns down the input level of your
music sources from Channels 1-4. Talkover is very
useful for making announcements without adjusting any
levels.
Try using this feature for audience participation
when you want the music to temporarily cease
and the audience to be heard - “YEAH!”
M A S T E R / B O O T H O U T P U T S E C T I O N
12. The Stereo Master Fader controls the overall
output level.
13. Stereo/Mono toggle adjusts the Master output
for the operation selected.
14. The Z o n e L e v e l controls speaker volume for a
remote zone or booth monitors. If you do not use
booth monitors the output can feed a tape deck,
another amplifier, another mixer or a satellite speaker
system.
N O T E : The Zone control on the DM1235 and
DM1285 is located to the right of the crossfader
section.
N O T E : This can also be used to supply line level
audio to a lighting controller or to lights that are
sound activated.
C O N T R A C T O R N O T E: Booth Level provides
zone control in installations where there are two
separate rooms. For example,a bar and dance floor.
Remote zone volume should be controlled from the
mixer.
15. Stereo Auto Peak Hold Level Indicator. This
fast, accurate stereo meter tracks the output level.
The Red LEDs for +3dB, +5dB and +8dB hold
program peaks for a second or two. With peak
metering, it's OK to be "in the Red" as long as +5dB
or +8dB aren't constantly lit. Set the crossover,
equalizer and power amp inputs to avoid distortion at
each step in the audio chain. Proper attention to the
peak meter results in the punchiest possible sound
without audible distortion.
Numark - The Leader in DJ Technology
©1998 Industries 8 http://www.numark.com