NordicTrack NTTL25513 - Manual (Page 11)

11
HOW TO USE THE MANUAL MODE
Insert the key fully into the console.
See GETTING STARTED on page 10.
Select the manual mode.
When the key is inserted, the manual mode will
automatically be selected. If a program has been
selected, press the Select Workout Goal button
repeatedly until the words “MANUAL MODE”
appear in the main display.
Press the Start button or the Speed + button to
start the walking belt.
A moment after the button is pressed, the walking
belt will begin to move at 1 mph. Hold the handrails
and begin walking. As you exercise, change the
speed of the walking belt as desired by pressing
the Speed + and – but-
tons. Each time a but-
ton is pressed, the
speed setting will
change by 0.1 mph; if a
button is held down, the
speed setting will
change in increments of 0.5 mph. To change the
speed setting quickly, press the 1-step Speed but-
tons. The speed range is 0.5 mph to 12 mph.
To stop the walking belt, press the Stop button.
The time will begin to flash in the main display. To
restart the walking belt, press the Start button or
the Speed + button.
Note: During the first few minutes that the treadmill
is used, inspect the alignment of the walking belt
and align it if necessary (see page 27).
Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the
Incline
▲ ▲ and ▼ ▼ buttons.
Each time a button is
pressed, the incline will
change by 0.5%. To
change the incline quickly, press the 1-step Incline
buttons. The incline range is 0% to 12%. Note: After
the buttons are pressed, it may take a moment for
the treadmill to reach the selected incline setting.
Follow your progress with the LED track, the
Training Zone display, and the main display.
The LED track—When
the manual mode or the
iFIT.com mode is se-
lected, the program dis-
play will show an LED
track representing 1/4
mile. As you exercise, the indicators around the
track will light in sequence until you have walked or
run 1/4 mile. A new lap will then begin.
The Training Zone
display—As you ex-
ercise, this display
will show the approxi-
mate intensity level of
your exercise. For ex-
ample, if seven to twelve indicators in the display
are lit, your intensity level is ideal for fat burning.
The main display—The main display will show
the following information:
Incline—The left side of
the main display shows
the incline level of the
treadmill.
Distance/Laps—The
next section of the main
display shows the dis-
tance that you have
walked and the number
of 1/4-mile laps you have
completed. The display will change from one num-
ber to the other every few seconds, as shown by
the indicators.
Calories/Heart Rate—
When you are not using
the handgrip pulse sen-
sor, the center of the
main display will show
the approximate number
of calories you have burned. When you are using
the handgrip pulse sensor, the display will show
your heart rate (see step 6 on page 12).
Time/Pace—When the
manual mode or the
iFIT.com mode is se-
lected, the main display
will show the elapsed
time and your current
pace (pace is measured in minutes per mile). The
display will change from one number to the other
5
4
3
2
1