NordicTrack GRT 950 NTSY39210 - Manual (Page 9)

9
12. Route the Hack Squat Cable (20) around the
other Pulley (19) attached to the Hack Squat
Base (1) in step 10, and through the Hack Squat
Leg (2).
14. Wrap the Hack Squat Cable (20) around a Pulley
(19). Attach the Pulley and a Cable Trap (18) to
the left hole in the top of the Hack Squat Upright
(4) with an M10 x 125mm Bolt (41), a 15mm x
8mm Spacer (46), an M10 Washer (36), and an
M10 Locknut (32).
Wrap the Hack Squat Cable (20) around another
Pulley (19). Attach the Pulley and a Cable Trap
(18) to the other hole in the Hack Squat Upright
(4) in the same manner.
Make sure the Cable Traps (18) are positioned
to hold the Hack Squat Cable (20) in the
grooves of the Pulleys (19).
15. Attach the end of the Hack Squat Cable (20) to
the end of the rear cable (F) with a Cable Clip
(34).
13. Route the Hack Squat Cable (20) under a Pulley
(19) and through the Hack Squat Upright (4).
Attach the Pulley inside the Upright with an M10 x
65mm Bolt (35), two 15mm x 12mm Spacers (17),
two M10 Washers (36), and an M10 Locknut (32).
12
13
14
15
20
20
17
19
36
35
2
1 19
4
4
20
41 19
18
18
46
Left
Hole
46
32
36
36
20
F
34
40
32