NordicTrack NTEX03990 - Manual (Page 9)

9
Inspect and tighten all parts of the exercise cycle
regularly. Replace any worn parts immediately. The
exercise cycle can be cleaned with a soft, damp cloth.
Avoid spilling liquid on the console. Keep the console
out of direct sunlight or the display may be damaged.
TIGHTENING THE PEDALS
For the best performance, the pedals must be kept
properly tightened. Regularly tighten both pedals.
BATTERY REPLACEMENT
If the console does not function properly, the batteries
should be replaced. See assembly step 6 on page 6 for
instructions.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. In order to adjust the
reed switch, the Left Side Shield (9) must be removed.
Using an adjustable wrench, turn the Left Pedal (19)
clockwise and remove it from the Left Crank Arm (26).
Next, remove the two M4 x 16mm Screws (64), the
M4 x 6mm Screw (77), and the seven M4 x 38mm
Screws (72) from the Left Side Shield (9). Grip both
Side Shields at the top and gently pull them apart.
Make sure that the Left Crank Arm (26) is in the posi-
tion shown in the drawing above. Carefully slide the
Left Side Shield (9) forward off the Left Crank Arm
and remove it.
Locate the Reed Switch (66). Turn the Left Crank Arm
(26) until the Magnet (44) is aligned with the Reed
Switch. Loosen, but do not remove, the M4 x 16mm
Screw (64). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Turn the
Crank for a moment. Repeat until the console displays
correct feedback. When the Reed Switch is correctly
adjusted, reattach the Left Side Shield and the Pedal.
HOW TO ADJUST THE DRIVE BELT
The exercise cycle features a precision belt that must
be kept properly adjusted. If the belt causes exces-
sive noise or slips as you pedal, the belt should be
checked. To do this, the left side shield must first be
removed. Refer to the instructions at the left and
remove the left side shield. Next, use an adjustable
wrench to turn the right pedal counterclockwise and
remove it. Remove the right side shield.
Press down on
the center of the
Drive Belt (33)
between the front
and rear pulleys.
There should be
from 1/4” to 1/2”
of vertical move-
ment in the cen-
ter of the Drive
Belt. If the Drive
Belt needs to be
adjusted, tighten
the M8 Nylon Locknut (74). When the Drive Belt is
properly adjusted, reattach the side shields and the
pedals.
MAINTENANCE AND TROUBLE-SHOOTING
9
72
19
26
72
72
77
64
66
26
64
44
Front View
74
33