NordicTrack NATL81205.0 User Manual
Page 8
8
8.
Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 27).
To protect the
floor or carpet from damage, place a mat under the treadmill.
6. Set the console assembly on the Uprights (69).
Make sure
that no wires are pinched. Finger tighten a Console Bolt
(78) with a Star Washer (77) into the lower hole in each
Upright (only one side is shown).
Next,
finger tighten a Short Console Bolt (106) with a
Star Washer (77) into the upper hole in each Upright (69)
(only one side is shown).
Be careful not to drop the
Short Console Bolts into the Uprights. Firmly tighten
the two Console Bolts (78) and the two Short Console
Bolts.
Insert an Upright Endcap (79) into the top of each Upright
(69) (only one side is shown). Note: Insert the end of the
Upright Endcap indicated by the arrow first; use a rubber
mallet if necessary.
106
69
77
77
78
Console
Assembly
79
7. Press the Latch Knob Sleeve (70) into the left Upright (69).
Note: It may be helpful to use a rubber mallet to fully insert
the Latch Knob Sleeve.
Remove the knob from the pin. Make sure that the collar
and the spring are on the pin as shown.
Note: If there
are two collars, place one on each side of the spring.
Insert the pin into the Latch Knob Sleeve (70) and the left
Upright (69).
Tighten the knob back onto the pin.
69
70
Knob
Pin
Collar
Spring
5. Have a second person hold the console assembly near the
Uprights (69). Connect the Upright Wire Harness (98) and
the Pulse Wire (66) to the wires extending from the console
assembly.
The connectors should slide together easily
and snap into place. If they do not, turn one connector
and try again. Then, insert the connectors into the console
assembly.
Connect the Upright Ground Wire (11) to the ground wire
extending from the console assembly.
Make sure that
the wires are fully connected. Then, insert the ground
wires into the console assembly.
69
98
Console
Assembly
Ground
Wire
66
11
98
66
5
6
7