Niles Audio Speaker - Manual (Page 19)

NILES AUDIO CORPORATION – 1-800-BUY-HIFI
FINISHING THE INSTALLATION
PAINTING THE GRILLE AND FRAME
After drywall is up, each HDFX frame and grille may be painted without the need for primer. For
best results, use a spray gun or airless sprayer, thin the paint to prevent clogging of the grille holes,
and apply several light coats instead of one heavy one.
1. Paint each grille and let it dry before installation.
2. Paint each frame and let it dry before installation.
INSTALLING THE FRAME
1. Fill each wall cavity with insulation. Remember to use equal amounts of insulation for
each loudspeaker.
2. For existing construction, slip the mounting bracket through the hole and pull it toward
you so that its front edge slides into the hole and stops in place.
NOTE: FOR NEW CONSTRUCTION, THE MOUNTING BRACKET SHOULD ALREADY BE IN PLACE
(AS DESCRIBED IN THE SECTION
NEW CONSTRUCTION: INSTALLING A BRACKET ON PAGE 14.
3. Attach each frame to its bracket using the supplied screws, as shown in Figure 14.
The screws should pull the frame and bracket together (sandwiching the drywall)
so that the frame is absolutely flush with the wall surface. There should be no gaps
between the wall and the frame.
IMPORTANT: DO NOT OVER TIGHTEN THE SCREWS! OVER TIGHTENING THEM MAY MAKE
THE GRILLE DIFFICULT TO INSTALL.
17
Figure 14. Installing the
frame into a mounting bracket.
DS00421ACN_HDFX.indd 19 5/6/05 5:05:35 PM