Nokia BH-112 - Manual (Page 4)

Warning:
Use only chargers approved by Nokia for use with this particular model. The use of any
other types may invalidate any approval or warranty, and may be dangerous. Use of
unapproved chargers may present a risk of fire, explosion, or other hazard.
1 Connect the charger to a wall outlet.
2 Connect the charger cable to the charger connector on the headset. The red indicator
light turns green when the battery is fully charged.
3 Disconnect the charger from the headset, then from the wall outlet.
When you unplug a charger, hold and pull the plug, not the cord.
The fully charged battery has power for up to 5 hours of talk time or up to 150 hours of
standby time.
When the battery charge is low, you hear a voice prompt, the headset beeps every 5
minutes, and the red indicator light flashes. When the battery is charging, the red
indicator light is on.
Check the battery charge
Make sure the headset is switched on, and press . A green light indicates a sufficient
charge level. If the light is yellow, you may need to recharge the battery soon. If the
light is red, recharge the battery.
Switch the headset on or off
Switch on
Press and hold for 2 seconds. The headset beeps, and a green indicator light flashes
once.
The headset connects to the last connected device. If you have never paired the headset
with a device, or you have cleared the device pairings, pairing mode is activated.
Switch off
Press and hold for 2 seconds. The headset beeps, and a red indicator light flashes
once. All active calls are ended.
If not connected to a device within 30 minutes, the headset switches off.
Pair and connect the headset to your phone
Before using the headset, you must pair and connect it to a compatible phone.
4