Fcc and industry canada information, Installing batteries, Installing batteries setup of the wii remote plus – Nintendo Wii Remote Plus MAA-RVL-A-WR-USZ-C0 User Manual

Page 4

Advertising
background image

5

6

3

4

Wii Remote

Jacket

1.

Open the lever on the strap lock and place

your hand through the wrist strap. Hold the

remote firmly in your hand.

1.

Press the Power button on the Wii console to turn it on.

2.

Remove the battery cover on the back of the remote. Press and release the SYNC. button inside

the cover. The Player LEDs will blink.

3.

Open the SD Card Slot cover on the front of the Wii console. Press and release the SYNC. button

on the inside of the compartment.

4.

When the Player LED blinking stops, connection is complete. The LED that is illuminated

indicates the player number.

5.

Close the SD Card Slot cover on the front of the Wii console and replace the battery cover on the

Wii Remote Plus.

2.

Slide the strap lock up so that the strap will

not fall off your wrist. Do not over tighten the

strap lock so that it’s uncomfortable. It should just

be tight enough to hold the wrist strap in place.

Close the lever to hold the strap lock in place.

Wearing the Wii Remote Wrist Strap

Synchronizing your Wii Remote Plus with the Wii console

Warranty and Service Information

Rev. R

FCC and Industry Canada Information

Regulations for Equipment Use in U.S.A. and Canada

This device complies with Part 15 of the FCC rules and RSS-210 of Industry Canada. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation. Changes or modifications not expressly approved

by the manufacturer could void the user's authority to operate this device.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

The term IC before the certification/registration number only signifies that the Industry Canada technical specifications

were met.

5.

If you remove the jacket from the remote,

replace it by inserting the top of the remote

into the large hole on the front of the jacket.

Be sure to push it all the way into the inside of

the jacket.

Thread the wrist strap through hole in the

bottom of the jacket, as shown in step 4, above.

6.

Insert the connector cover into the

External Extension Connector on the bottom

of the remote.

Installing Batteries

(continued)

This procedure must be followed for each additional Wii Remote Plus added to your system.

You may need only simple instructions to correct a problem with your product. Try our web site at

support.nintendo.com or call our Consumer Assistance Hotline at 1-800-255-3700, rather than going to

your retailer. Hours of operation are 6 a.m. to 7 p.m., Pacific Time, Monday - Sunday (times subject to change). If

the problem cannot be solved with the troubleshooting information available online or over the telephone, you

will be offered express factory service through Nintendo. Please do not send any products to Nintendo without

contacting us first.
HARDWARE WARRANTY

Nintendo of America Inc. ("Nintendo") warrants to the original purchaser that the hardware product shall be free

from defects in material and workmanship for twelve (12) months from the date of purchase. If a defect covered by

this warranty occurs during this warranty period, Nintendo will repair or replace the defective hardware product or

component, free of charge.* The original purchaser is entitled to this warranty only if the date of purchase is

registered at point of sale or the consumer can demonstrate, to Nintendo's satisfaction, that the product was

purchased within the last 12 months.
GAME & ACCESSORY WARRANTY

Nintendo warrants to the original purchaser that the product (games and accessories) shall be free from defects in

material and workmanship for a period of three (3) months from the date of purchase. If a defect covered by this

warranty occurs during this three (3) month warranty period, Nintendo will repair or replace the defective product,

free of charge.*
SERVICE AFTER EXPIRATION OF WARRANTY

Please try our web site at support.nintendo.com or call the Consumer Assistance Hotline at 1-800-255-3700 for

troubleshooting information and repair or replacement options and pricing.*

*

In some instances, it may be necessary for you to ship the complete product, FREIGHT PREPAID AND INSURED

FOR LOSS OR DAMAGE, to Nintendo. Please do not send any products to Nintendo without contacting us first.
WARRANTY LIMITATIONS

THIS WARRANTY SHALL NOT APPLY IF THIS PRODUCT: (a) IS USED WITH PRODUCTS NOT SOLD OR LICENSED BY

NINTENDO (INCLUDING, BUT NOT LIMITED TO, NON-LICENSED GAME ENHANCEMENT AND COPIER DEVICES,

ADAPTERS, SOFTWARE, AND POWER SUPPLIES); (b) IS USED FOR COMMERCIAL PURPOSES (INCLUDING RENTAL); (c)

IS MODIFIED OR TAMPERED WITH; (d) IS DAMAGED BY NEGLIGENCE, ACCIDENT, UNREASONABLE USE, OR BY OTHER

CAUSES UNRELATED TO DEFECTIVE MATERIALS OR WORKMANSHIP; OR (e) HAS HAD THE SERIAL NUMBER ALTERED,

DEFACED OR REMOVED.

ANY APPLICABLE IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A

PARTICULAR PURPOSE, ARE HEREBY LIMITED IN DURATION TO THE WARRANTY PERIODS DESCRIBED ABOVE (12

MONTHS OR 3 MONTHS, AS APPLICABLE). IN NO EVENT SHALL NINTENDO BE LIABLE FOR CONSEQUENTIAL OR

INCIDENTAL DAMAGES RESULTING FROM THE BREACH OF ANY IMPLIED OR EXPRESS WARRANTIES. SOME STATES

DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR EXCLUSION OF CONSEQUENTIAL OR

INCIDENTAL DAMAGES, SO THE ABOVE LIMITATIONS MAY NOT APPLY TO YOU.

This warranty gives you specific legal rights. You may also have other rights which vary from state to state or

province to province.

Nintendo's address is: Nintendo of America Inc., P.O. Box 957, Redmond, WA 98073-0957 U.S.A.

This warranty is only valid in the United States and Canada.

The Wii Remote Plus uses AA batteries. Nintendo recommends high quality alkaline batteries for best

performance and longevity of battery life. If you use rechargeable nickel metal hydride (NiMH)

batteries, be sure to follow the manufacturer’s guidelines for safety and proper usage.

1

. Pull the Wii Remote Jacket off the base of

the Wii Remote Plus and pull the wrist strap

out of the hole in the bottom of the jacket.

2

. Pull the jacket up the remote far enough

to expose the entire battery door and remove

the door.

3

. Insert the batteries into the battery

chamber. Be sure to insert the minus (–)

end first when inserting new batteries,

and remove the plus (+) end first when

replacing the batteries.

4

. IMPORTANT: If this is the first time

you have installed batteries in the Wii

Remote Plus, you must synchronize the

remote with the Wii console before

using it. See the next page,

Synchronizing your Wii Remote Plus

with the Wii console, for instructions.

Then return to Step 4.

Replace the battery cover, thread the wrist

strap through the hole in the bottom of the

jacket and pull the jacket back over the

bottom of the remote.

The Wii Remote Plus comes with the Wii Remote Jacket

installed.

• Be sure that the Wii Remote Jacket is installed

during gameplay to reduce the risk of harm to the

remote, surrounding objects, or people.

• It may be necessary to remove the Wii Remote

Jacket – for example, to replace the batteries in the

Wii Remote Plus. If you do remove the Wii Remote

Jacket, be sure to replace it before further play.

Installing Batteries

Setup of the Wii Remote Plus

Advertising