NordicTrack NTL1895.1 - Manual (Page 6)

ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver and
wire cutters . For help identifying the assembly hardware, see the hardware drawings below.
1. With the help of a second person, carefully raise the
Uprights (20) and the Walking Platform (15) to the posi-
tion shown.
While the other person holds the Uprights (20) and the
Walking Platform (15), slide the Extension Legs (90)
onto the two brackets on the base of the Uprights.
Make
sure that the Extension Legs are turned so the Base
Pads (81) are beneath them. Note: It may be helpful to
tip the Uprights forward as you slide the Extension Legs
onto the brackets.
6
1” Tek Screw (82)–4
Console Bolt (72)–2
3
Handrail Bolt (66)–4
Star Washer (67)–12
3/4” Screw (7)–2
Extension Screw
(87)–4 Short Console
Bolt (112)–2
Pulse Bar Bolt (13)–4
81
Brackets
81
20
15
90
90
1