Using two par4 routers, Specifications – Niles Audio Simplified Infrared Router PAR4 User Manual
Page 10
9
S
I
M
P
L
I
F
I
E
D
I
N
F
R
A
R
E
D
R
O
U
T
E
R
Using Two PAR4 Routers
You may daisy chain two PAR4 IR routers together to provide
routing for up to eight identical devices. This is accomplished
by connecting two PAR4 routers together using a mono
3.5mm cable (not supplied). See figure 6. On PAR4 “B” the
3.5mm cable is plugged into the “IR cascade out” jack. On
PAR4 “A” the 3.5mm cable is plugged into the jack labeled “IR
input”.
Operation for two units is similar to operating a single PAR4
with the exception that a separate table of IR routing codes
(table A and table B) exists for PAR4 (A) and PAR4 (B).
Note: When two PAR4 IR Routers are daisy chained
together codes from table A will not operate PAR4
unit B and vice versa.
Specifications
Unit Dimensions
7-1/16” wide x 1-1/4” high x 3” deep
Power Requirements
12VDC 1.25A regulated power supply (included).
DS00429ACN_PAR4.qxp 3/30/05 3:06 PM Page 9