Nilfisk-Advance America P 130.1 - Manual (Page 6)

6
Operating Instructions
EN
Separate detergent container
1. Remove the cover with suction hose from the
detergent container.
2. Mount the cover with suction hose on the separate
detergent container.
The cover has a standard thread and fi ts common
detergent containers. If your container does not have
a standard thread, detach the fi lter from the suction
hose and remove the cover. Remount the fi lter in the
suction hose.
Extra detergent hose can be pulled out of the ma-
chine.
2.5 Regulation of pressure / water
volume
This function is not available on model B.
Working pressure and water volume can be regu-
lated on the machine by turning the button for regu-
lation of pressure / water volume (14). The pressure
can be read on the pressure gauge (13).
2.6 Suction mode
The machine can take in water from a rain water
butt as an example. In the suction mode, the inlet
hose must be fi lled with water before starting up the
machine. The water inlet hose must not be too long,
approx. 5 m.
1. Make sure that the water butt is not placed on a
lower level than the ma chine.
2. Attach the water inlet hose to the ma chine and
place the other end of it in the water butt.
3. Start the machine.
4. Detach the spray lance and activate the trigger of
the spray lance. Keep the trig ger activated until
water has come out for approx. 15 sec onds.
5. Remount the spray lance and the ma chine is
ready for operation.
NOTE: The internal fi lter of the machine is not
intended for the fi ltration of large quan ti ties of im-
purities. If the water contains leaves, sand or the
like, an external suction fi lter should be mount ed.
For further in for ma tion, please contact your near est
Nilfi sk dis trib u tor.
2.7 End of operation
1. Stop the machine by turning the start/stop switch
(2) to pos. O.
2. Disconnect the plug from the sock et.
3. Shut off the water supply and ac ti vate the trigger
(6a) to relieve the machine of pres sure.
Concerning storage, please refer to section 5.0.