Eizo FlexScan L353T-C - Manual (Page 25)

English
4-2. Color Adjustment
The <Color> menu in the ScreenManager enables to change the color of the screen. By
using the <Color Mode>, the adjustment mode can be selected from <Custom mode> (to
adjust the color settings according to your preference) and <sRGB> mode.
In the analog input, perform the “Range Adjustment” (p.23) before making the
color adjustments.
NOTE
• Allow the LCD monitor to stabilize for at least 20 minutes before making image
adjustments. (Allow the monitor to warm up for at least 20 minutes before making
adjustments.)
• Performing the <Reset> of the <Color> menu returns the color settings to the
default settings
• The values shown in percentages represent the current level within the specific
adjustment. They are available only as a reference tool. (To create an uniform white
or black screen, the percentages for each will probably not be the same.)
Adjustment Contents
Color Mode Menu
Custom sRGB
Function Descriptions Adjustable range
Brightness
√ √
To set the brightness of the
screen 0
∼ 100%
To set the color temperature 4,000
∼ 10,000 K
in 500 K increments
(including 9,300 K).
Default setting is off
(normal white)
Temperature
(p.41)
√
-
NOTE
•
The values shown in the Kelvin are available only as a
reference tool.
•
Setting the temperature under 4,000 K or over 10,000
K invalidates the color temperature setting. (The color
temperature’s setting turns “OFF”.)
To set the gamma value 1.8
∼ 2.6 Gamma
(p.41)
√
-
NOTE
•
If setting the gamma value, the using the monitor in
the digital signal input is recommended.
If using the monitor in the analog input signal, set the
gamma value from 1.8 to 2.2.
4. ADJUSTMENT
25