Introduction – Nostalgia Electrics Retro RSM-702 User Manual
Page 5
 
ENGLISH
3
INTRODUCTION
 
 
Now you can enjoy icy, cool snow cones to snack on when…… 
 
Watching TV or a Movie at Home
Throwing a Party
Listening to music
Craving a Low fat Treat
And more…
 
The SINGLE CONE RETRO SNOW CONE MAKER™ is easy to use, just follow these 
simple instructions: 
 
After Taking the Unit Out of the Box 
A.
Your SINGLE CONE RETRO SNOW CONE MAKER™ is already fully assembled. 
Before first use, lift the removable top off of the body and wipe clean the inside of 
the unit with a non-abrasive moist sponge, a non-abrasive towel, or a damp cloth 
followed by a non-abrasive dry towel. 
B.
After cleaning the inside, put the top back on the base of the unit.
C.
Now you are ready to enjoy cool, refreshing icy snacks from your SINGLE CONE 
RETRO SNOW CONE MAKER™. 
USING YOUR SINGLE CONE RETRO SNOW CONE MAKER™
First, find a stable surface near an electrical outlet before starting. (Make sure your cord is 
away from any water source. If needed, it is acceptable to use an extension cord.) 
 
1. 
Before plugging in your unit, add ice cubes by removing the clear top from your 
SINGLE CONE RETRO SNOW CONE MAKER™. In order to do so, turn the 
clear top clockwise, lift and remove. Once you have done this, plug in the unit. 
 
For Optimal Ice Shaving Results – Your ice cubes should sit a short while before putting 
them in the shaving unit. If your ice has a frosty look, it is much too hard to shave. If your 
ice sits long enough to look clear and it is wet to the touch, then it is ready to make your 
SINGLE CONE RETRO SNOW CONE MAKER™ experience a fun one. 
2.
When ice cubes are ready, place cubes in the shaving unit allowing enough room 
for the lid to be placed back on the unit easily. 
3.
Place a cone in the snow cone holder so the shaved ice does not spill onto your 
countertop. 
4.
Return the clear lid to the unit and turn counter-clockwise to the ON position. This 
will activate the unit to begin shaving. (To turn “OFF” simply turn the lid 
clockwise.) 
5.
Repeat steps 3 and 4 until you have shaved the amount of ice desired. Make 
sure to unplug when you are finished. 
6.
Use the recipes found on the next page to create your favorite snow based 
treats!