Numark Industries CDN 36 - Manual (Page 11)

CDN 36
RELAY PLAY
1. Insert CDs into both of the units.
2. Press the “RELAY” button.
3. Press play on the first unit. When that unit stops play it will send a signal to the second unit to start play. You
will see the second unit start play and the first unit pause. When unit 2 has completed play unit 1 will start.
Note: The play signal is sent at the end of specified play. If the unit is in SINGLE mode the play signal will
start the second unit at the end of the track. If the unit is in CONTINUOUS mode the play signal will be
sent at the end of the full CD. Two CDs will play continuously, alternating from unit to unit.
FADER START
Fader Start is achievable by attaching your CD player to a similarly equipped DJ mixer and setting the rear panel
selection switch to “mixer” mode.
1. Connect cables between the CD player and your DJ mixer.
2. Press the button or switch on your mixer into fader start mode to activate the fader start capability.
3. Typically if you move the crossfader toward the active channel, the attached CD player will activate. When it is
moved away the unit will cue or pause depending upon CD player setting.
To select start/stop mode hold the time button for 3 seconds.
If the display shows then the CD will pause when the crossfader is moved away.
If the display shows then the CD will CUE when the crossfader is moved away.
REMOTE SWITCH START
Remote switch start is achievable by attaching your CD player to a switch like a foot switch found in most music
shops. Foot switch connector plugs are often ¼” and an adapter to 1/8” will be needed for connection.
1. Connect the remote switch to your CD player.
2. Select the type of foot switch you will use. There are two types of footswitches that will work with this connector.
The first is a typical, ON-OFF pushbutton switch and are generally used for switching channels on guitar amps.
The second switch is a momentary footswitch and is usually used for keyboard sustain pedals. If you are unsure
of the style of switch you have, try each position until it works as desired.
3. Typically if you press the switch once, the attached CD player will activate. When it is pressed again the unit will
cue or pause depending upon CD player setting.
Note: You can also use a momentary switch in the ON-OFF switch position. In this case the unit will only
play while the switch is depressed. When the button is release it will either cue or pause depending upon
mode.
- The Leader in DJ Technology
©2002 Numark Industries - 11 - http://www.numark.com