Numark Industries MPCD3 - Manual (Page 9)

CDN15/MPCD3
- The Leader in DJ Technology
©2002 Numark Industries - 9 - http://www.numark.com
DISPLAY FEATURES
1. CUE: Flashing when the unit is setting a cue point. Lit continuously when the unit is paused at a cue point.
2. PAUSE (II): Active when the unit is paused.
3. PLAY (>): Active while the unit is actually playing a CD.
4. TRACK: Shows the track that the unit is playing.
5. TOTAL: indicates when total CD remaining tracks are displayed.
6. MINUTES: Shows the minutes elapsed or remaining depending on mode setting.
7. SECONDS: Shows the seconds elapsed or remaining depending on mode setting.
8. FRAMES: The CD Player breaks down a second into 75 frames for accurate cueing. This shows the frames
elapsed or remaining depending on mode setting.
9. AUTOSTART: will light when the unit is set to relay from CD unit to CD unit.
10. CONTINUOUS PLAY: Shows when the unit is set to play back the entire CD without stopping between
tracks.
11. SINGLE PLAY: Shows when the unit is set to play just one track at a time.
12. CD IN: indicates a CD is in the unit.
13. TIME BAR: Shows either track elapsed time, remaining track time, or remaining total time depending on the
setting of the “time” button.
TIME MODE:
14. REMAIN indicates when track remain time is displayed.
15. TOTAL indicates when total CD remain time is displayed.
note: both indications will not be lit when the unit is showing “elapsed” time
16. SEARCH: indicates when the unit is searching through the music.
17. PITCH DISPLAY: indicating current pitch.
18. PROGRAM: Indicates when a track sequence has been programmed in the memory.
19. MP3 (MPCD3 only): Indicates when an MP3 CD is in the drawer.