NEC DT100 - Manual (Page 34)

E-29
Operation
Main control
BRIGHTNESS
Remote control
BRIGHT
Main control
ZOOM
Remote control
ZOOM
1
2, 3, 4
■ Basic Operation in the OHP Mode
The functions described here can only be used when your projector is set for OHP use.
NOTE
• In the case of the OHP projection (material projection), there may be distortion more or less because an
ultra-wide lens is used.
1
Open the scanner cover and place the materi-
als to be projected on the scanner.
Close the cover.
NOTE
• Though materials can be projected without closing the materials cover, unwanted light, etc., may enter the
scanner, making the projected image more difficult to view.
2
Select the magnification.
You can adjust the magnification between 100% and 200%.
Press the left button to reduce the magnification or the right
button to increase the magnification.
NOTE
The brightness will change slightly if you alter the magnification.
3
Adjust the brightness.
To darken the image, press the button on the left. Conversely,
to lighten the image, press the button on the right.
NOTE
• When the materials or printed matter are nearly black, adjust the brightness to increase, and when they are
nearly white, adjust it to decrease.