NordicTrack 2200 R NTL1595.1 - Manual (Page 8)

8
5. Cut the tie securing the wires to the Uprights (20). Have a
second person hold the console assembly near the right
Upright. Connect the Upright Wire Harness (73) and the
Pulse Wire (74) to the wires extending from the console as-
sembly.
The connectors should slide together easily
and snap into place. If they do not, turn one connector
and try again. Insert the connectors into the console as-
sembly.
Connect the Upright Ground Wire (101) to the ground wire
extending from the console assembly.
Make sure that
the wires are fully inserted into each other. Insert the
ground wires into the console assembly.
20
73
Console
Assembly
Ground
Wire
74
101
5
73
74
7. Remove the knob from the pin. Make sure that the collars
and the spring are on the pin as shown.
Press the Latch Insert (77) into the left side of the Upright
(20) as shown. Use a rubber mallet if necessary. Insert the
pin into the Latch Insert, and tighten the knob back onto
the pin.
77
7
Knob
20
Pin
Collar
Spring
8. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 27).
To protect the
floor or carpet from damage, place a mat under the treadmill.
6. Set the console assembly on the Uprights (20). Make sure
that no wires are pinched. Finger tighten a Console Bolt
(72) with a Star Washer (67) into the lower hole in each
Upright (only one side is shown).
Next, finger tighten a Short Console Bolt (110) with a Star
Washer (67) into the upper hole in each Upright (20) (only
one side is shown).
Be careful not to drop the Short
Console Bolts into the Uprights. Firmly tighten all four
Console Bolts.
Press an Upright Endcap (71), the end indicated by the
arrow first, into each side of the Upright (20) (only one side
is shown). Use a rubber mallet if necessary.
110
20
67
67
72
71
6
Console
Assembly