Т³гж 4 – Numark Industries WS32 User Manual
1. Frequency Range: VHF 170~250 MHZ.
2. Frequency Stability
0.005% quartz oscillation controlled.
4. Frequency Response:50Hz~18KHz
5. Hum & Noise:96dB min.
6. Dynamic Range:100dB min.
7. Distortion:less than 1%.
Wireless Microphone Features and Specification
1. Antenna:built-in with noise terminator circuit.
3. Current Consumption:30mA.
4. Power Output:20mW
5. Spurious Emission:45dB min.
Wireless Receiver Features and Specification
1.Quartz controlled fixed frequency receiving mode.
2.Sensitivity: 10dB/uV(S/N 60dB).
3.Image and Spurious Rejection: min 80dB.
4.Output: unbalanced 0.15V 600
5.Receiver System: single channel non-diversity.
6.Power Source: DC 12V.
FEATURES AND SPECIFICATION
Insert adapter DC plug into receiver DC input jack, insert the other AC plug
into AC power supply outlet(According to the sign on the back side).
Sound Signal Output Jack: Insert one end of the cable connector plug into
signal output jack at the back of the receiver and the other end of the plug
into KTV or amplifier MIC-IN jack.
Push on receiver
s power switch, if power LED indicator on front panel
lights, this indicates that receiver works normally.
Insert attached 9V battery into wireless microphone's battery compartment
(pay attention to the positive and negative pole), and then close the cover.
Turn on microphone power switch, LED indicator will flash once then off ,
it indicates that microphone is ready to use.
At this time receiver's RF LED indicator will light. Adjust volume control
to make receiver
s volume to be in normal working state. Finish test of