Netopia 4522 T1 User Manual
Page 10
2-4 Getting Started Guide
Netopia 4522 back panel
.
1.
Connect the mini-DIN8 connector from the power adapter to the power por t, and plug the other end into an
electrical outlet.
2.
Connect one end of the Categor y 5 cable to the T1 por t, and the other end to your T1 wall outlet.
3.
Connect the Ethernet cable to the Ethernet por t on the router and the other end to your computer.
You should now have: the power adapter plugged in; the Ethernet cable connected between the router and
your computer; and the T1 cable connected between the router and the T1 wall outlet.
Port
Description
T1 WAN por t
An RJ-48 jack labeled WAN for your T1 connection.
Ethernet por t
RJ-45 10/100Base-T Ethernet jack. You will use this to configure the Netopia 4522. For
a new installation, use an Ethernet connection. Alternatively, you can use the console
connection to run console-based management using a direct serial connection. You can
either connect your computer directly to the Ethernet por t using a crossover Ethernet
cable (not supplied), or connect both your computer and the Netopia 4522 to an existing
LAN environment.
Console por t
A DB-9 console por t for a direct serial connection to the console screens. You can use
this if you are an experienced user. See
“Connecting a Console Cable to Your Router” on
.
Power por t
A mini-DIN8 power adapter cable connection.
WAN
10/100
Console
Power
T1 port
Ethernet port
Console port
Power port
Ethernet