NISSAN TITAN 2010 - Manual (Page 317)

5. Remove the dipstick again and check the oil
level. It should be between the H (High) and
L (Low) marks
᭺
B . This is the normal oper-
ating oil level range. If the oil level is below
the L (Low) mark
᭺
A , remove the oil filler cap
and pour recommended oil through the
opening. Do not overfill
᭺
C .
6. Recheck oil level with the dipstick.
It is normal to add some oil between oil
maintenance
intervals or during the
break-in period, depending on the severity
of operating conditions.
CAUTION
Oil level should be checked regularly. Op-
erating the engine with an insufficient
amount of oil can damage the engine, and
such damage is not covered by warranty.
CHANGING ENGINE OIL
1. Park the vehicle on a level surface and apply
the parking brake.
2. Start the engine and let it idle until it reaches
operating temperature, then turn it off.
3. Remove the oil filler cap
᭺
A by turning it
counterclockwise.
4. Place a large drain pan under the drain plug
᭺
B .
5. Remove the drain plug
᭺
B with a wrench by
turning it counterclockwise and completely
drain the oil.
LDI0371 WDI0504
Maintenance and do-it-yourself 8-9