NordicTrack MTN 740 NTCCM58020 - Manual (Page 16)

16
Inspect and tighten all parts of the stepper regularly.
The stepper can be cleaned with a soft cloth and a
small amount of mild, non-abrasive detergent. Keep
liquids away from the console.
HOW TO ADJUST THE REED SWITCH
For the console to display correct feedback, the pedals
must move at least five inches with each step. If the
console displays incorrect feedback when the pedals
are moved five inches or more, the Reed Switch (56)
should be adjusted.
Remove the right Pedal Bracket (13) by removing the
two M10 x 82mm Button Bolts (26) and the two M10
Nylon Locknuts (not shown). Then, remove the two M4
x 38mm Screws (64) and the three M4 x 25mm Screws
(65). Carefully slide the Right Side Shield (8) off the
stepper.
Turn the Flywheel (46) until the Magnet (32) is aligned
with the Reed Switch (56) (refer to the inset drawing).
Loosen the indicated Screw (52). Slide the Reed
Switch slightly closer to the Flywheel, and retighten
the Screw.
Make sure that the Magnet will not hit
the Reed Switch when the Flywheel turns. Repeat
until the console displays correct feedback.
Carefully slide the Right Side Shield (8) back onto the
stepper. Reattach the three M4 x 38mm Screws (64)
and the two M4 x 25mm Screws (65). Reattach the
Pedal Bracket (13).
HOW TO LEVEL THE STEPPER
If the stepper rocks
slightly during use,
turn one or both of
the Feet (15) under
the Stabilizer (2) until
the stepper is level.
TROUBLESHOOTING AND MAINTENANCE
52
32
46
15
2
13
64
65
26
8
56