Nortel Networks COOLPIX S1100PJ - Manual (Page 187)

173
Changing the Projector Settings (Projector Settings Menu)
U
sin
g th
e pro
je
cto
r
k Auto Off
If no operations are performed for a while during projection, camera ends
projection and enters standby mode (
A 21) for saving the power.
In this option, set the time allowed to elapse before the camera enters standby
mode.
30 s, 1 min, 5 min (default setting), and 30 min can be selected.
C
Canceling Standby Mode
• When the camera enters standby mode from projector mode, press the power switch, shutter-
release button or c button to activate playback mode.
• Press the A button to activate shooting mode.
• To resume projection, press the P button again in playback mode or shooting mode.
C
Notes on Auto Off
The time allowed to pass before the camera enters standby mode is fixed as follows:
• During slide show playback with the loop option enabled: 30 minutes
• When a setting screen or the projector settings menu is displayed: three minutes
Tone Compensation
Dark portions of pictures are brightened when projected.
P button (projector mode) M Tap the bottom tab M z (Projector settings menu) M
k Auto off
P button (projector mode) M Tap the bottom tab M z (Projector settings menu) M
Tone compensation
On (default setting)
Dark portions of pictures are brightened when projected. The results of tone
compensation vary depending on the picture.
Off
Tone compensation is disabled.