Northern Industrial Tools 15000 PPG - Manual (Page 23)

Operation (cont’d)
23
2. Preparing for Operation
Position
generator Position generator in accordance with the instructions given in
“Installation & Initial Set-up, Step 4: Select a Suitable Site” of this
manual.
Operate outside only, on dry, level ground with adequate clearance and
ventilation.
WARNING: Carbon monoxide poisoning hazard
Generators give off carbon monoxide exhaust, a poisonous gas that can
kill. You CANNOT smell it, see it, or taste it. ONLY run generator
OUTDOORS and away from air intakes. NEVER run generator inside
any enclosed or semi-enclosed spaces, including homes, garages,
basements, sheds, boxes, pick-up truck beds, RVs, or boats. These spaces
can trap poisonous gases, EVEN if you run a fan or open windows.
Carbon monoxide exhaust is given off whether you are using gasoline,
natural gas, or propane to power the generator.
Ground
generator Make sure the generator is grounded in accordance with instruction given
in
“Installation & Initial Set-up, Step 5: Grounding the Generator” of
this manual.
WARNING: Electric shock hazard
Always ensure generator is properly grounded to prevent electrical shock.
Perform
scheduled
maintenance as
needed Make sure that any regular maintenance has been performed as prescribed
in this manual in the “Maintenance & Repair”
section.
1. Refer to the engine owner’s manual for engine maintenance instructions.
2. Make sure battery is charged. Charge as needed according to your
battery manufacturer’s instructions.
Check/add oil Check the oil level using the dipstick and add oil as needed.
Using a funnel, add oil up to the FULL mark on the dip stick with the
recommended oil type for your engine and expected ambient conditions.
(See engine Owner’s Manual for oil type and capacity, and more detailed oil
check/fill instructions.)
WARNING: Burn hazard
Never open oil port while engine is running. Hot oil can spray over face
and body.
˙
Notes:
o
Low oil shutdown feature prevents the generator from starting without
sufficient oil.
o Engine is shipped without oil. You must add oil before first use.
IMPORTANT:
Under long, continuous-run operating conditions, be prepared to:
• Check engine oil level every time you refuel the engine.
• Change oil after the first 20 operating hours, and at least every 100 operating
hours thereafter, or as directed in engine owner’s manual.