NordicTrack NTHK99901 - Manual (Page 6)

6
Assembly
Assembly requires two people. Set the TREKKER in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own Phillips screwdriver .
Note: The underside of the TREKKER walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect performance. If there is lubricant on top of the walking belt, simply wipe off the lubri-
cant with a soft cloth and a mild, non-abrasive cleaner.
1. Identify the right Upright (23), which has the Upright Wire
Harness (100) inside of it. Slide an Upright Collar (54)
onto the Upright.
100
54
23
1
3. Slide the Upright Collar (54) to the position shown.
Finger tighten three Upright Bolts (33) with Upright
Washers (32) into the right Upright (23). Note: It may be
necessary to move the Upright slightly to align the holes.
Attach the left Upright (not shown) in the same way.
Note: There is not a wire harness in the left Upright.
Do not tighten the Upright Bolts (33) yet.
3
23
32
32
33
33
54
2. Remove the six Upright Bolts (33) from the right and left
posts on the Base (101).
While a second person holds the right Upright (23), con-
nect the Upright Wire Harness (100) to the Base Wire
Harness (41) in the right post on the Base (101). Insert
both Wire Harnesses into the post.
Make sure that the right Upright (23) is in the position
shown in drawing 1. Note: If the Upright Bolts are in the
holes in the post, remove them. Slide the Upright onto the
right post on the Base (101) and align the indicated holes.
Be careful not to pinch the Wire Harnesses (100, 41).
23
101 Holes
Hole
Hole
Holes
100
41
2