Nexgrill 720-0133-LP - Manual (Page 10)

Step 9: Replace “U” brackets with 4(four) Step 10: Align & start knob bezel & valve
Screws( DO NOT TIGHTEN) Screws as shown below (DO NOT
and stem with 2(two) screws & washers TIGHTEN)
. (
Step 11; Tighten all 4(four) screws on the “U” Step 12: Place knob on valve stem and secure
brackets on the burner, then connect with Allen wrench
the ignition wire on to valve. (wrench enclosed in bag)
8
ASSEMBLY INSTRUCTIONS