NordicTrack NTCCBE19520 - Manual (Page 7)

7
9. Orient the two Pulley Housings (26) as shown.
Slide the Eyebolt/Pins (51, 52) into a set of holes
in the Pulley Tubes (12).
Route a Nylon Rope (23) through a Pulley
Housing (26) in the direction shown. Route the
other Nylon Rope through the other Pulley
Housing as shown.
10. Insert the ends of the two Rope Storage Knobs
(31) into the square holes in the Carriage Plates
(49, not shown). Attach the Rope Storage Knobs
to the Carriage (6) with two M6 x 61mm Screws
(47).
Route the Nylon Ropes (23) through the Rope
Grips (28). Pull on the Ropes so that they are
secure in the teeth on the Rope Grips.
Wrap the ends of the Nylon Ropes (23) around
the Rope Storage Knobs (31).
11. Make sure that all parts have been properly tight-
ened. The use of the remaining parts will be
explained in ADJUSTMENTS, beginning on the
following page.
9
10
26
52
51
12
23
23
12
31
31
47
47
28
23
6