NordicTrack APEX NTTL18903 - Manual (Page 6)

ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own flat-bladed screwdriver .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
6
2. With the help of a second person, carefully raise both
Uprights (83) to a vertical position. Make sure that the
Lock Knob Sleeve (87) is in the left Upright.
Next, make sure that the Lock Pin Collar (89) and the
Spring (88) are on the Lock Pin (91). (Note: If there are
two Lock Pin Collars, place one on each side of the
Spring.) Insert the Lock Pin into the Lock Knob Sleeve
(87) and the Left Upright (83).
Press the Lock Knob Spacer (86) onto the left Upright
(83). Tighten the Lock Knob (85) onto the Lock Pin (91).
83
86
87
85
88
89
91
2
1. Slide the treadmill out of the box. Insert the three Cage
Nuts (28) into the three indicated holes in the treadmill.
To insert each Cage Nut (28), first hook one side of the
Cage Nut into the hole and then use a flat-bladed screw-
driver to press the other side into the hole, as shown.
28
28
1
3. With the help of a second person, carefully raise the
Frame (7) to the storage position and make sure that the
lock pin is properly engaged as described on page 25.
Position the Base Plate (115) on the treadmill as shown.
Attach the Base Plate with the three Base Plate Screws
(114). Note: It may be helpful if a second person tips the
treadmill slightly as you tighten the Screws.
Carefully lower the Frame (7) to the floor as described on
page 25.
115
7
114
3