NordicTrack NTL2495.2 User Manual

Page 10

Advertising
background image

10

If you purchase the optional chest pulse sensor (see page 12), follow the steps below to install the re-
ceiver included with the chest pulse sensor.

8.

Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrenches in a secure place. The allen wrench is used to adjust the walking belt (see page 31).

To protect

the floor or carpet from damage, place a mat under the treadmill.

1.

Make sure that the power cord is unplugged.

2. Remove the indicated 3/4” Screw (95) and the Access

Door (121) from the bottom of the Console Base (98).

3. Connect the wire on the receiver (A) to the indicated wire

extending from the Console Base (98).

Hold the re-

ceiver so the small cylinder is oriented as shown and
is facing the Console Back.
Attach the receiver to the
plastic posts on the Access Door (121) with the two in-
cluded small screws.

4.

Make sure that no wires are pinched. Reattach the
Access Door (121) with the 3/4” Screw (95). Discard the
other wires included with the receiver.

A

98

Small

Cylinder

121

95

Wire

Small

Screws

6.

Note the location of the 75 ohm antenna terminal on
the treadmill. For the television to operate properly, an
antenna, a CATV cable, or a VCR must be connected
to the 75 ohm antenna terminal.

If you are using an antenna, it must be properly con-
nected and adjusted for optimal reception. See ANTENNA
CONNECTIONS on page 26 to properly connect an an-
tenna.

If you are using a CATV cable, see CATV

CABLE CONNECTION on page 26 to properly connect
the cable.

If you are using a VCR, see HOW TO CON-

NECT A VCR on page 27 to properly connect the VCR.
The VCR must be turned on, a videocassette must be
properly inserted, and the VCR must be playing. See
your VCR user’s manual for operating instructions.

75 Ohm Antenna Terminal

6

7. Remove the battery cover from the back of the Remote

Control (137). Insert two “AAA” batteries (not included)
into the battery compartment;

make sure that the bat-

teries are oriented as shown by the diagram inside of
the battery compartment.
Reattach the battery cover.

137

“AAA” Batteries

Battery Cover

7

Advertising